Recent content by becausefu

You can always trim down the front sight post

Hornady critical defense is in my G42 .....

The BEST thing .... they have the no BS warranty as well

Use a clamp on and it doesn't walk ....

An A2 flash hider sure does need to be timed.

Use a barrel vise is my suggestion

Fuck no you aren't going to hurt anything. I suggest using either a reaction rod, a magpul action block or a barrel vise to do it. I wouldn't use just an upper clamshell type holder. You could twist the barrel in the upper by using just a clamshell. Tighten it as tight as you can without...

Use a crush washer .... crush the washer until it lines up where you want it ......especially for a standard flash hider. Nothing to it.

Ok ... here is how I would have done the clip on the lcr ...... I would have made a cylinder "extension" out of wood so it would mimic the contours of the cylinder all the way to the back of the grip. Use more wood to make the extension look like a T or a cross depending on where I wanted to...

Bushnell trs25 is on my 9mm ar

I BUILT this one myself ... after it's all said and done there was over 1700 in it. But you can buy complete mags from MBX ... just look them up online ....they aren't cheap ...about $140 or so per mag. But buying a cheap STI mag then replacing everything in it costs about that much too.

You know that mags for that are 6 times what a Glock mag costs

I'm 7 years quit ....I still want one dally

Just think about how much you could have saved if you only got what you had ordered.

I have an 18 tooth can .... use it on an AR and a couple 22's