Polymer 80 "Glock"

American Revival Apparel Company

Righter13

Student of life
Lifetime Supporter
Mar 24, 2015
1,788
1,165
113
Greenville SC
Zip code
17268
IMG_6066.JPG IMG_6065.JPG IMG_6054.JPG My quest for a numberless gun begins here IMG_6034.JPG

Lessons learned.

Factory slide stop is best. The Ghost brand one has a slightly shorter spring that can come undone.

Make sure you file out the guide rod channel very well. Otherwise you get a very gritty slide pull.

The ejector may need minimal nudging to get the slide on the first few times.

Suarez Magwell fits BUT you have to narrow the bottom of the front strap. Took maybe 5minutes w a dremel.
 
Last edited:

Mac11FA

Disgruntled large member
Super Moderator
Lifetime Supporter
Patriot Lifetime
Mar 26, 2015
3,840
3,011
113
Locust Grove, GA
Zip code
30248
Please make sure to list a build sheet with part sources and pricing. I am definitely interested! Are the lowers available for all Glocks?
 
  • Like
Reactions: Righter13

Righter13

Student of life
Lifetime Supporter
Mar 24, 2015
1,788
1,165
113
Greenville SC
Zip code
17268
Please make sure to list a build sheet with part sources and pricing. I am definitely interested! Are the lowers available for all Glocks?
Basically it's the kit and whatever Glock upper you want to run it on.

Polymer80.com is the place to go.
 
  • Like
Reactions: Mac11FA

Righter13

Student of life
Lifetime Supporter
Mar 24, 2015
1,788
1,165
113
Greenville SC
Zip code
17268
IMG_6038.JPG IMG_6039.JPG IMG_6040.JPG IMG_6041.JPG This was all done with a Dremel and a hand drill. Now I'll be filing the rest down using files and sand paper.

I could probably do a little more using the dremel but no need to risk it.
 

Mac11FA

Disgruntled large member
Super Moderator
Lifetime Supporter
Patriot Lifetime
Mar 26, 2015
3,840
3,011
113
Locust Grove, GA
Zip code
30248
  • Like
Reactions: dial1911

Righter13

Student of life
Lifetime Supporter
Mar 24, 2015
1,788
1,165
113
Greenville SC
Zip code
17268
That's loozing good! A little sanding will clean it right up! I bet some finexpensive sandpaper wrapped around a wooden dowel may help with the curvy parts.
did this using a small round file and some WD-40. This is by far the hardest part. IMG_6043.JPG
 
  • Like
Reactions: Mac11FA

Righter13

Student of life
Lifetime Supporter
Mar 24, 2015
1,788
1,165
113
Greenville SC
Zip code
17268
IMG_6044.JPG Lesson learned- no need for aftermarket mag release. The factory one becomes an extended one due to how the frame is cut