Search results

I highlighted the problem for you .. hopefully you can find it easier.

It's not that way with efile, if there's a problem they kick it out and make you start over. If it is a paper file, then yes, they will send it back have you correct it and it will usually go thru immediately then.

Not everyone has a set of knipex pliers. Aero Precision taps the hole from the factory ....makes it easier putting on the receiver end plate, or when putting on an A2 stock you don't have to worry about the spring sticking out. Why buy a special tool to do something when you probably have...

Three little tricks. The rear take down spring hole ..... tap it with a 4/40 tap and use a set screw to hold it in place, clip about 4 coils off the spring before using it. Second trick, front take town pin ....put the spring in the hole and use a punch to compress the spring, take a needle...

SIt there and cycle that bitch by hand while watching TV ....put a little bit of valve grinding compound on the rails and cycle the piss out of it to loosen the rails up if they seem tight.

Not really, take the 75 grain Amax in .224 diameter. It is longer than a 75 grain bthp, longer to the point that you cannot load them to mag length for an AR .... but you can the 75 grain bthp.

Little secret ...when Cabellas does a sale have it shipped to the store to avoid hazmat

There are slight varients between bullet companies .....one 115 grain round nose might be .375 long ....another company might be .382 long ....they are both 115 grain bullets but seating the longer bullet to the same COAL as the shorter one is going to put more bullet in the case and could...

Buy the classic .... anything else is just a gimmick really. Some have nibx coated take down and pivot pins .....what the fuck is the purpose of that? Some will swap the A2 grip for a magpul one. Some offer an upgraded trigger ..... Just buy a standard mil spec

As a former holster maker, I never used any loctite on the screws, especially on a holster that could be adjusted by the end user. I would set everything up in standard form and send it out. Who wants to get a holster and want to adjust it and strip out a screw cause its loctited in place.

Ok ...the JP spring is cool ...I've had one. But there are limitations to it. Some pros, the spring isn't hitting the tube so the noise isn't there in your ear. Can buy various springs of different weights to play with the recoil impulse and how light or firm the force on the bolt carrier is...

I honestly don't see the point in them

I bet this mother fucker knows what he's talking about with a seating stem

It's more than just that ... they have the beginnings of the hole but it would need extra milling to make it a machine gun. They caught it before the ATF did and the ATF hasn't made a specific ruling on this case. But IWI is calling them back because it could technically be considered a...

I built this as a fun gun ... an AR pistol in a rifle cartridge is not fun indoors. Leaving it for the wife is secondary really

This if the MFT kit I think it is. Was like $84 shipped. The tube doesnt have the holes to adjust it ... there is just a solid bar like a typical adjustable stock. It's got a hole tapped in it and comes with a bolt to keep it from adjusting on you. I drilled another hole to get it where I liked it.

That is not a stock ..... that is a thordsen customs cheek rest .... it's pretty freaking slick and not expensive at all

Maybe this will help lol

Need 2 more pieces and this will be done, it's going to be my wife's home defense weapon when I'm not home, and it'll be my companion in the Jeep when out goofing off. I need to get a 3 rail piece of m lock to put on the handguard for a flashlight. And I need a 5.5" flashhider that NWS is...

Threaded barrel needs to be properly fit. They aren't just a drop in deal like a Glock barrel