Recent content by Shawn Agne

Talked to my friend above as we both were shooting a 3x600 at Cincy yesterday.  He said enough guys at his work (USNSW Crane were talking about it that he wrote up a brief)from  the eports they were getting back it was 12-15 shots.  Also it was a group of guys Mortar/RPG team so the rounds were...

We run a club fun match at Atterbury called Longest shot we start at 1000yds and it has been won the last couple time back at 2,000yds, KD3 goes back a little bit farther but we usually run out of time.  Also there are matches out west called King of 2 mile, friend of mine just participated in...

TRG-42 in 338LM. Shot it out to 1,900yds once in a Longest shot match, played with it a couple times. Other than that its a safe queen.

If we are just talking Ohio Camp Perry of course along with Miami Valley Rifle and Pistol down at Milford is nice as is Alliance Rifle Club near Malvern Ohio. Perry and Malvern are 1000yd ranges, MVR&P is a 600yd range. Not sure if Zanesville is a 500yd or 600yd range .

My two AR-10 course rifles are Armalite lower/uppers. I prefer the XTSP trigger over the Geissle. Other than that barrels are Kregier, Bartlein, or Obermeyer in no particular order. Rest of my stuff won't apply to you unless you're going to shoot NRA matches.

While bearing surface does play a part, with the identical mass you could use the load data for the 124/147s you found in the manual. As with anything start low and work up to what the gun likes.

Thank you for correcting my statement. I have heard that and always wondered how they could and not violate 4th amendment rights.

This is the equivalent of people wanting to work up 77gr 223 loads or 175gr 308 loads.........

Before I would drop that much money I would want to make sure the AR is actually firing in batter. A lot of times the "ways" to make stuff fire fully automatic are just causing the weapons to slam fire, and if that happens out of battery it isn't good.

I laugh at the whole tracked thing. We had shooters at Camp Atterbury who quit coming to matches when the base required us to get s/n's for the gate roster. Same thing happened at Ft. Knox for the Meade County matches. Some people decided they didn't want to turn stuff in because they didn't...

Fill out the Class III permit, pay your money. Local Sheriff needs to sign off on it I believe. Weapon needs to be kept in a safe if not in your possession. The ATF can come visit you to make sure it is in your possession or in a safe at their discretion. Having friends who have Class III...

Winchester Ranger T Series

fired cases are shorter than sized cases but if they're once fired you will be fine. Don't worry if they are different lengths. My 1000yd cases for my 280 and 243 aren't the same length and they shoot fine there so for 100yd don't worry about it. I'll look up my M193 load using H322 and 55's...

55gr FMJs or 52g BTHPs with around 25gr of a lot of powders works well. With the light bullets I like H322 with the little bullets as it meters great.

Yes remove the primer crimp, then size (make sure you've lubed the cases). You can then trim, but truth be told I haven't trimmed mine for awhile. If they are somewhere south of 1.760" you will be ok. After a couple firings you may want to check them. Trim length is 1.750" so I'm guessing...