Search results

Faktory 47
  1. Righter13

    Polymer 80 "Glock"

    It's just the trigger guard. I have a heat gun. It's already done.
  2. Righter13

    Polymer 80 "Glock"

    The frame is the registered part on a Glock though....
  3. Righter13

    Polymer 80 "Glock"

    What's the worst that can happen?
  4. Righter13

    Polymer 80 "Glock"

    Only if you're an FFL. I can have a licensed FFL perform work on it.
  5. Righter13

    Polymer 80 "Glock"

    I am, by the end of July. I need a holster sooner though. I want to use it in the TR class. I have some laying around here that I can prolly just re-mold to fit it.
  6. Righter13

    Polymer 80 "Glock"

    Will do. May pop off a few suppressed rounds in the snow today.
  7. Righter13

    Polymer 80 "Glock"

    I'd have to get it to ya in person. These frames used a standard 1913 rail and the trigger guard is a different shape as well.
  8. Righter13

    Polymer 80 "Glock"

    @Leshaire this thing needs it's own holster...
  9. Righter13

    Polymer 80 "Glock"

    Lol yeah. Hopefully I'll get the chance this week.
  10. Righter13

    Polymer 80 "Glock"

    Naw, just finished it a couple hours ago and now it's snowing. I've ran some snap caps through it lol.
  11. Righter13

    Polymer 80 "Glock"

    I'd say it's only better than my RTF in the sense of when I IWB it.
  12. Righter13

    Polymer 80 "Glock"

    Side by side targets of it and a factory g19?
  13. Righter13

    Polymer 80 "Glock"

    I like it. My EDC is a Gen 3 RTF so this is a nice relief from the rough grip of my EDC.
  14. Righter13

    Polymer 80 "Glock"

    It's easy to novice. It could all be done with hand files if you want too. I dremeled as much as I was comfortable with then used hand files and sand paper. The holes for the pins were by far the easiest part.
  15. Righter13

    Polymer 80 "Glock"

    @Leshaire @Red Dawn
  16. Righter13

    Polymer 80 "Glock"

    Lesson learned- no need for aftermarket mag release. The factory one becomes an extended one due to how the frame is cut
  17. Righter13

    Polymer 80 "Glock"

    did this using a small round file and some WD-40. This is by far the hardest part.
  18. Righter13

    Polymer 80 "Glock"

    This was all done with a Dremel and a hand drill. Now I'll be filing the rest down using files and sand paper. I could probably do a little more using the dremel but no need to risk it.
  19. Righter13

    Polymer 80 "Glock"

    Basically it's the kit and whatever Glock upper you want to run it on. Polymer80.com is the place to go.
  20. Righter13

    Polymer 80 "Glock"

    Yep, I can do the rest with a hand drill and dremel if I chose to.
Top Bottom